Configuring the Application Path

If the system displays a message indicating that the configured path is not supported, use the Kunpeng DevKit administrator account to modify Application Path on the System Settings tab page.

1. Add the application path.

   Click in the upper right corner of the page to go to the configuration page.

   Figure 1 Configuring the application path
   
2. In the Application Path Configuration box, if you need to configure multiple application paths, separate them with semicolons (,).
   

   You are advised to set the application path to a path such as /home/ or /opt/. Do not set the application path to a system directory such as /, /dev, /sys, or /boot. Otherwise, system exceptions may occur.