set

Command Function

Uses the parameters of a tuning round to assign values to and reset application or system parameters.

The set subcommand is used to change the parameter values. Exercise caution when running this subcommand.

Syntax

set [h] <n>

Example

• Applying the parameters of the round whose performance ranks first to the application and system

  1

  set 1

  The following information is returned if the parameters are set successfully:

  1	[2025-02-25 11:06:31 UTC] [KAT] [message] - set params of r1 success!

• Resets task parameters to restore the parameters in the application or system to those before the set command is run.

  1

  set 0

  If the resetting is successful, the following information is returned:

  1	[2025-02-25 11:06:55 UTC] [KAT] [message] - --------- kunpeng automatic tuning - Step <params recover> start -----------